Maple laminate flooring – Laminate flooring comes in a variety of finishes and colors. To Install maple laminate flooring, Make sure that the subfloor is flat. There should be no major bumps or gouges. If you install the laminate over a wood subfloor, simply use a hand sander to smooth inconsistencies. Concrete floors should be leveled by filling low spots with self-leveling and grind high spots with a cement mixer.
Maple laminate flooring, Cut housings of the door, so that the laminate will slide under the casting. Place a piece of maple laminate on top of a small piece of foam layer and place it next to the enclosure door. Use trims the board and the lower layer as a guide for the housing with a so-called dovetail saw. Wipe the floor with a broom. Install the foam layer. Roll it out in the same direction you are going to install the laminate planks. Tape the seams with packing or duct tape.
12 Photos Gallery of: Install Maple Laminate Flooring
Place the first board. Place a 1/4-inch spacer between the wall and the shelf. Cut off the end of the queue size with a miter saw. With the installation of the maple laminate flooring, and be sure to stagger the joints as you go. Measure the area for the last part with a tape measure and subtract the expansion joint. Cut the piece on a table saw and install it with a pull bar. Install form the skirting to hide the expansion joint. Use a nail gun to nail baseboards in place above the floor.